Enertech EAV060 - Condensation

Enertech Global 22
EAV - EME/EMD Rev. A Models
Installaon and Operaons Manual
Move from the street to the unit’s nal locaon. If the ground
allows, use a pallet truck to move the unit to the set up locaon.
If that is not available and you must li the unit into place
please do so as described below.
 The center of gravity is oset to one side (the right side
when looking at the front of the unit).
If the unit needs to be transported across so ground, such as
a lawn, a crane be used that can li the unit to the installaon
locaon. When the unit is lied with a crane, the packaging
must be undisturbed. (See the illustraon)
If a crane vehicle cannot be used the unit may be transported
on an extended hand truck with oversized turf res (dolly, two
wheeler). The unit must be taken from its heaviest side (right
side of unit when looking at the front). This unit is approaching
400 lbs so li accordingly using plenty of help as needed.
Recommended installaon for proper draining of
condensaon.






Before liing remove the packaging and the securing strap from
the pallet. Place liing straps around each machine foot. Liing
from the pallet to the base requires four persons, one for each
liing strap.

The condensate drain pan collects and drains away most of the
condensate from the heat pump.
It is important to the heat pump funcon that the condensate
run-o is not posioned so that it can cause damage to the
house. Run-o should be checked regularly especially during
the autumn for obstrucons by leaves and branches. Clean
if necessary. The condensate (up to 13 gallons/24 hrs) that
collects in the trough should be routed away by a pipe to an
appropriate area, it is recommended that the shortest outdoor
stretch possible is used.

