What to do if Enertech AV Heat Pump has low hot water temperature?
If you experience low hot water temperature with your Enertech Heat Pump, it may be due to large hot water consumption. In this case, wait until the hot water has heated up. Also, check whether alarm “high condenser out” (162) is displayed, and if so, inspect and clean the strainer.
Why is Enertech Heat Pump producing low room temperature in heating?
If your Enertech Heat Pump is producing low room temperature during heating, it could be due to several reasons. First, check if thermostats are off in several rooms and set them to max in as many rooms as possible. Also, check whether alarm “high condenser in” (163) or “high condenser out” (162) are displayed. If so, follow the instructions for adjusting flow rate.
What to do if there is ice build-up in Enertech AV Heat Pump?
If you notice ice build-up in the fan, grille, or fan cone on the outdoor module of your Enertech Heat Pump, the de-icing fan may not be activated. To resolve this, activate the “de-icing fan” in menu 5.11.1.1.
What to do if EAV is not in operation in Enertech AV?
If the EAV (Electronic Expansion Valve) is not in operation in your Enertech Heat Pump, ensure that the EAV is connected to the power source and that compressor operation is required. Also, check that the addressing of EAV is correct and that the communication cable has been connected.
To Next Page
General
