ENSONIQ DP/4+ User Manual

Section 3 — Config Parameters
8 ENSONIQ DP/4+ Reference Manual
05 — (Config Dependent)
This parameter is dependent on how Units A and B are routed (determined by parameter 02). If
parameter 02 is serial, this screen shows:
o5
Dry Path Around
AB Amt =00
This screen allows you to control an external dry signal around Units A and B. A setting of 00
would not allow a dry signal around the units, whereas a setting of 99 would permit a full signal
around the units.
BA
Wet
Dry
This parameter controls this amount.
If parameter 02 is feedback 1 or 2, this screen shows:
o5
Feedback B to A
Amount =00
This screen allows you to control a feedback signal from Units B to the front of Unit A. A setting
of 00 would not allow the feedback signal back into the units, whereas a setting of 99 would
permit a full feedback signal.
This parameter controls this amount.
BA
Wet
Feedback
If parameter 02 is parallel, this screen shows:
o5
AB Feedback not
available
This parameter does nothing because of the nature of a parallel connection, there is no dry path
(or feedback) around the units.

ENSONIQ DP/4+ Specifications

General

Brand	ENSONIQ
Model	DP/4+
Category	Recording Equipment
Language	English