Enterasys SecureStack C3G124-24P - C3 G124-24 P Stackable Switch

Overview
1-2 Introduction
•FourSFPslotsthatprovideyouwiththeoptionofinstallingSmallFormPluggable
(SFP)Mini‐GBICsfor1000BASE‐SX/LXfiber‐opticconnectionsand1000BASE‐T
copperconnections.
•Rearpanelconnectorsforhigh‐speedconnectionsinastackconfiguration.
•RearpanelRedundantPowerSupplyconnectorusedtoconnecttoaSecureStack
PoE
‐compliantRedundantPowerSupply(C2RPS‐POE).Theswitchconnectstothe
SecureStackC2RPS‐POEusingaSecureStackC2RPS‐POEcable.
The10/100/1000 Mbpsfixedfrontpanelportscanoperateineitherhalf‐duplexorfull‐
duplexmode,asdeterminedbyAuto‐Negotiation.
Figure 1-1 C3G124-24P Stackable Switch
Note: The Mini-GBIC ports cannot be active simultaneously with their corresponding
10/100/1000BASE-T ports. For example, if SFP port 24 establishes a link first on the
C3G124-24P, the 10/100/1000BASE-T built-in RJ45 port 24 is not available and
vice-versa.
Caution: The C3G124-24P and C3G124-48P are PoE-compliant devices. Do not connect
a SecureStack Redundant Power System (C2RPS-SYS) to the power connector.
Otherwise, damage to the device may result.
Precaución: Los dispositivos C3G124-24P y C3G124-48P cumplen con el estándar PoE
(power over ethernet). No conecte una fuente de poder redundante (RPS) SecureStack
(C2RPS-SYS) al cable de corriente. De lo contrario, el dispositivo puede dañarse.
1 DB9 RS232 console port connector 6 Mini-GBIC port status LEDs
2 System status LEDs 7 Two ports for stack connections
3 Twenty-four RJ45, 10/100/1000 Mbps, PoE ports 8 Password Reset switch
4 RJ45 port status LED
S 9 AC power input connector
5 Four slots for SFP interface modules
(Mini-GBICs)
10 RPS connector for SecureStack PoE
redundant power supply connection
C3G124-24P