Enterasys SecureStack C3G124-24P

Connecting to Console Port for Local Management
SecureStack C3 Installation Guide 3-19
Figure 3-9 DB9 Male Console Port Pinout Assignments
Connecting to an IBM or Compatible Device
ToconnectanIBMPCorcompatibledevice,runningtheVTterminalemulation,toa
switchConsoleport(Figure 3‐10),proceedasfollows:
1. ConnecttheDB9femaleconnectoratoneendofthecable(notsupplied)tothe
Consoleportontheswitch.(Ifthereisaswitchdesignatedas
theManager,connectto
itsConsoleport.)
2. Plug theDB9femaleconnectorattheotherendofcableintothecommunicationsport
onthePC.
3. TurnonthePCandconfigureyourVTemulationpackagewiththefollowing
parameters:
Whentheseparametersareset,theStartupscreenwilldisplay.Proceedto“Connecting
to
theNetwork”onpage 3‐22.
1 Pin 2, Received Data (input)
2 Pin 3, Transmitted Data (output)
3 Pin 5, Signal Ground
All other pins not connected.
Â
À
Á
5
1
9
6
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit