Enterasys SecureStack C3G124-24P

Management
SecureStack C3 Installation Guide 1-7
Management
Managementoftheswitchcanbeeitherin‐bandorout‐of‐band.In‐bandremote 
managementispossibleusingTelnet,Enterasys Networks’NetSight
®
management
application,ortheWebViewapplication.Out‐of‐bandmanagementisprovidedthrough
theRJ45COM(Communication)portonthefrontpanelusingaVT100terminalora
VT100terminalemulator.
Switch Configuration Using WebView
Enterasys Networks’HTTP‐basedWebmanagementapplication(WebView)isan
intuitivewebtoolforsimplemanagementtasks.
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteswitchconfiguration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackC3ConfigurationGuide.
Standards Compatibility
The1000BASE‐Tportsarecompliantwiththefollowingstandardsandoperations:
• IEEE802.3
• IEEE802.3u
• IEEE802.3ab
•Full‐Duplexoperation
TheSFPportsarecompliantwiththefollowingstandardsandoperations:
• IEEE802.3z
• IEEE802.3xFlowControlsupportforFull‐Duplexmode
•Auto‐negotiationforFull‐Duplexcontroloperation
Thestackingportprovides
20GbpsperportconnectedtoMemberswitchesforupand
downlinkconnections.