Enterasys SecureStack C3G124-24P - Page 67

Using the Reset Switch
SecureStack C3 Installation Guide 4-9
Toresettheswitchpassword,refertoFigure 4‐3andproceedasfollows:
1. Press‐and‐holdtheResetswitchwhiletheswitchdeviceisoperational.Thischangeof
theloginpasswordtothedefaultpasswordwillbeindicatedthroughCLIonly.
2. Logontodevicemanagement.Youcannowlogontotheswitch
throughtheConsole
portandassignanewpasswordusingthecommandlineinterface(CLI).
3. ToaccessswitchmanagementfromyourlocalPC,terminal,ormodemconnection,
refertotheSecureStackC3ConfigurationGuideforinstructionsonhowtologinand
enteranewpassword.Theguideisavailable
at:
http://www.enterasys.com/support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage xvi.
Note: Notify the system manager before changing the password.