Item Explanation
Buffer Size Determines the amount of memory to be used for receiving data and printing data.
Note:
❏ To activate Buffer Size settings, you must turn off the printer for more than five
seconds then turn it back on. Or, you can perform a Reset All operation, as
explained in Reset Menu.
❏ Resetting the printer erases all print jobs. Make sure the Ready light is not
flashing when you reset the printer.
Settings (default in bold):
Normal, Maximum, Minimum
Network Menu
See the Network Guide for each setting.
Note:
❏ In order to do IP address settings for AL-M220DN’s first setup, you must install EpsonNet Config for Windows or
for Mac OS X. Note that you cannot do IP address settings using EpsonNet Config on a web browser for the first
setup. For details, see the IP Address and Password Setup Sheet, and Network Guide.
❏ After any item in the menu is changed, the setting takes effect after a warm boot or after the power is turned on
again. While it is reflected in the Status Sheet, the actual change takes effect after a warm boot or after the power is
turned on again.
Energy Saver Menu
Note:
To use EpsonNet Config with a web browser to do settings, access Configuration > Common Settings > Energy Saver
Menu.
Item Explanation
Time to Sleep(Auto) When this setting is set to Enable, the printer automatically determines the time to enter
the sleep or deep sleep mode, based on the operation history of the printer. Note if Enable
is selected, the Time to Sleep and Eco Fuser settings are ignored.
Settings (default in bold):
Enable, Disable
Time to Sleep Specifies the length of the time until the printer enters the sleep mode or deep sleep mode
if there are no button operations and no jobs to be printed.
Settings (default in bold):
1Min, 3Min, 5Min, 15Min, 30Min, 60Min, 120Min
AL-M320DN/AL-M310DN/AL-M220DN User's Guide
Getting to Know Your Printer
25
To Next Page
Loading...
Need help?
General