Sleep Schedule Menu
Note:
You need to use EpsonNet Config with a web browser to reset the history, because this item is not displayed on the control
panel. See the Network Guide for the procedure to access EpsonNet Config with a web browser.
Item Explanation
Reset Operate History Resets the printer’s operation history, which is based on the Time to Sleep(Auto)
calculation.
Sleep Schedule Sets a start time and a sleep pattern for up to fiv e time periods through the day. The Sleep
Pattern options are as follows:
❏ On: Enters sleep mode according to the Time to Sleep(Auto) or Time to Sleep
settings.
❏ Quick: Enters sleep mode as soon as possible.
Note:
For an image of these settings, see “Making a weekly sleep schedule” on page 60.
Excluded Day Specifies a special date on which to apply the sleep pattern for some other day, and
specifies the day for up to two days. Each specified date setting is valid once within the
each coming specified date.
Sleep Status Displays the status of the sleep settings for one week starting from the current day. For
example, after Time to Sleep(Auto) is set to Enable, you can check if each time-to
sleep value, based on the operation history, has been calculated or is still being prepared.
Reset Menu
Item Explanation
Clear Warning Clears warnings except for those that occur from consumable products or
mandatory-replacement parts.
Clear All Warnings Clears all warnings that are shown on the LCD panel or by LED lights.
Reset All Stops printing and clears the printer memory. The print jobs received from all interfaces
are erased. Also resets the life counters for maintenance units A and B.
Note:
Performing Reset All clears print jobs received from all interfaces. Be careful not to
interrupt someone else’s job.
Reset Maintenance A Counter Reset the maintenance unit life counter when you replace the maintenance unit. For
instructions on replacing the maintenance unit, see the documentation supplied with the
maintenance unit.
Note:
After Performing Reset Maintenance Counter A or Reset Maintenance
Counter B, the printer reboots automatically. Be careful not to interrupt someone
else’s job.
Reset Maintenance B Counter
AL-M320DN/AL-M310DN/AL-M220DN User's Guide
Getting to Know Your Printer
27
To Next Page
Loading...
Need help?
General