Item Explanation
Toner Save When this setting is selected, the printer saves toner by substituting a gray shade for the
black inside of characters. The characters are outlined in full black on the right and lower
edges.
Settings (default in bold):
Off, On
Density Specifies the printing density. The printout becomes darker as the value increases.
Settings (default in bold):
1, 2, 3, 4, 5
Emphasize Thin Lines Adjusts the weight of thin lines sothey are printed clearly. The correction results differ
depending on the application software.
More: Makes thin lines even easier to see (thickens them) than Emphasize, and then prints
them
Emphasize: Makes thin lines easier to see (thickens them), and then prints
Off: Prints without emphasizing thin lines
Top Offset Makes fine adjustments to the vertical printing position of the page.
c
Important:
Make sure that the printed image does not extend beyond the edge of the paper.
Otherwise, you may damage the printer.
Settings (default in bold):
-99.0 ... 0.0 ... 99.0 mm in 0.5 mm increments
Left Offset Makes fine adjustments to the horizontal printing position of the page.
c
Important:
Make sure that the printed image does not extend beyond the edge of the paper.
Otherwise, you may damage the printer.
Settings (default in bold):
-99.0 ... 0.0 ... 99.0 mm in 0.5 mm increments
T Offset B Adjusts the vertical printing position on the back of the paper when printing on both
sides. Use this if the printout on the back is not where you expected.
Settings (default in bold):
-99.0 ... 0.0 ... 99.0 mm in 0.5 mm increments
L Offset B Adjusts the horizontal printing position on the back of the paper when printing on both
sides. Use this if the printout on the back is not where you expected.
Settings (default in bold):
-99.0 ... 0.0 ... 99.0 mm in 0.5 mm increments
AL-M320DN/AL-M310DN/AL-M220DN User's Guide
Getting to Know Your Printer
30
To Next Page
Loading...
Need help?
General