Item Explanation
CGTable Use the character generator (CG) table option to select the graphics character table or the
italics table. The graphics table contains graphic characters for printing lines, corners,
shaded areas, international characters, Greek characters, and mathematical symbols. If
you select Italic, the upper half of the character table is defined as italic characters.
Settings (default in bold):
PcUSA, Italic, PcMultilin, PcPortugue, PcCanFrenc, PcNordic, PcTurkish2, PcIcelandic,
PcE.Europe, BpBRASCII, BpAbicomp, Roman-8, PcEur858, ISO Latin1, 8859-15 ISO,
PcSl437,PcTurkish1, 8859-9 ISO, Mazowia, CodeMJK, PcGk437, PcGk851, PcGk869, 8859-7
ISO, PcCy855, PcCy866, PcUkr866, PcLit771, Bulgarian, Hebrew7, Hebrew8, PcHe862,
PcAr864, PcAr864Ara, PcAr720, PcLit774, Estonia, ISO Latin2, PcLat866
Country
Use this option to select one of the fifteen international symbol sets. See the Font Guide for
samples of the characters in each country’s symbol set.
Settings (default in bold):
USA, France, Germany, UK, Denmark, Sweden, Italy, Spain1, Japan, Norway, Denmark2,
Spain2,LatinAmeric, Korea, Legal
Auto CR Specifies whether the printer performs a carriage-return/line-feed (CR-LF) operation
whenever the printing position goes beyond the right margin. If you select Off, the
printer does not print any characters beyond the right margin and does not perform any
line wrapping until it receives carriage-return character. This function is handled
automatically by most applications.
Settings (default in bold):
On, Off
Auto LF If you select Off, the printer does not send an automatic line-feed (LF) command with
each carriage-return (CR). If On is selected, a line-feed command is sent with each
carriage-return. Select On if your text lines overlap.
Settings (default in bold):
Off, On
Bit Image The printer is able to emulate the graphics densities set with the printer commands. If you
select Dark, the bit image density is high, and if you select Light, the bit image density is
low.
If you select BarCode, the printer converts bit images to bar codes by automatically filling
in any vertical gaps between dots. This produces unbroken vertical lines that can be read
by a bar code reader. This mode will reduce the size of the image being printed, and may
also cause some distortion when printing bit image graphics.
Settings (default in bold):
Dark, Light, BarCode
ZeroChar Specifies whether the printer prints a slashed or unslashed zero.
Settings (default in bold):
0, (or the zero character with a slash)
AL-M320DN/AL-M310DN/AL-M220DN User's Guide
Getting to Know Your Printer
34
To Next Page
Loading...
Need help?
General