Info Menu
118
Event ID
code
Cause and solution
0434
0481
0482
0485
Unstable network communication. Check the network
communication status, wait a few moments, and try connecting to
the network again.
0483
04FE
The network software quit unexpectedly. Check the network
communication status, then turn the projector off and then on again.
0484 Communication with computer was disconnected. Restart the
network software.
0479
04FF
A projector system error has occurred. Turn the projector off and
then on again.
0891 Cannot find an access point with the same SSID. Set your computer,
access point, and projector to the same SSID.
0892 The WPA/WPA2/WPA3 authentication type does not match. Make
sure the wireless network security settings are correct.
0893 The TKIP/AES encryption type does not match. Make sure the
wireless network security settings are correct.
0894 Communication with an unauthorized access point was
disconnected. Contact your network administrator.
0895 Communication with a connected device was disconnected. Check
your device connection status.
0898 Failed to acquire DHCP. Make sure the DHCP server is operating
correctly. If you are not using DHCP, set the DHCP setting to Off in
the projector's Network menu.
0899 Other communication errors.
089A The EAP authentication type does not match the network. Check the
wireless LAN security settings and make sure that the security
certificate is installed correctly.
089B EAP server authentication failed. Check the wireless LAN security
settings and make sure that the security certificate is installed
correctly.
Event ID
code
Cause and solution
089C EAP client authentication failed. Check the wireless LAN security
settings and make sure that the security certificate is installed
correctly.
089D Key exchange failed. Check the wireless LAN security settings and
make sure that the security certificate is installed correctly.
Light Source Info
s Info > Light Source Info
You can view the projector's light source information.
Light Source Hours
Displays the number of operating hours for each of the projector's Light
Source Mode settings.
Estimated Remains
If the Constant Brightness setting is enabled, displays the remaining
number of hours the projector can maintain constant brightness.
s Settings > Brightness Settings > Constant Brightness
Version
s Info > Version
You can view the projector's firmware information.
Status Information
s Info > Status Information
You can view the projector's basic status information.
Each category contains the following information.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
