Attaching and Removing a Lens
34
a
If you are projecting from a table or other flat surface, the image may
be tilted depending on your lens. Adjust the tilt of the image using the
front and rear feet.
Removing a Lens
You can remove a lens to replace it with a different lens.
Caution
Wait at least 30 minutes to remove or replace the lens after turning off the
projector. Touching the lens unit before it cools down may cause burns.
a
The projector uses a laser as the light source. As a safety measure, the
light source turns off when the lens is removed. Attach the lens, and
then press the [On] button to turn it back on.
a
Hold down the [Lens Shift] (remote control) or [Lens] (control panel)
button for approximately 3 seconds to move the lens to the home
position.
b
Turn off the projector and unplug the power cord.
c
Remove the lens replacement cover.
d
If necessary, loosen the screw next to the lock lever.
To Next Page
Loading...
