Multi-Projection Features
130
a
• You can change the number of the displayed points using the
Points setting.
• To continue to move another point, press [Esc] and then
repeat the previous steps.
• To adjust another boundary line, press [Esc] until the screen is
displayed.
j
If you are combining images from multiple projectors on a network,
select the Screen Matching setting to adjust the brightness and tint of
the images.
a
The required time for screen matching varies depending on the
layout and number of projectors. It can take up to approximately
18 minutes.
k
If the projectors are not connected to a network or you want to adjust
manually after performing automatic adjustments, select the Color
Matching setting to adjust the brightness and tint of the images
manually.
• Select a value for the Adjustment Level setting, and adjust the color
tone for the Red, Green, or Blue settings, and then adjust the
Brightness setting.
• Repeat these steps as necessary to adjust each adjustment level.
l
Select the Scale setting to select sections of the images.
• Set the Scale setting to Auto or Manual first.
• Select the Scale Mode setting and select one of the following options:
• Zoom Display to maintain the image aspect ratio as you scale the
image.
• Full Display to adjust the image to the projector's screen size as
you scale the image.
• Select one or more of the following scaling options and adjust it as
necessary:
• - or + to scale the image horizontally and vertically at the same
time.
To Next Page
Loading...
