Epson EB-W06 Service Manual

EB-E01 series Troubleshooting INTERNAL USE ONLY
SEIKO EPSON 42 Revision A
 Lamp: Lamp Error
 Lamp On: Lamp Lit Error
 Lamp Off: Lamp Failure
Take out the lamp and check if
the Lamp is cracked or
damaged.
If the Lamp is cracked/
damaged,
replace it with a new one.
P.43
Air Filter condition
(dirt accumulation, clogging)
If clogging is found, clean or
replace the Air Filter.
If the projector has been used at
a place where is 1500 meters or
higher above sea level:
If the High altitude mode is
ON, set it to OFF.
After trying above remedies:
If the same error occurs after
turning the power back on,
check the error name and carry
out the remedy referring to the
references on the right column.
LED Status
Corresponding error name Remedy Reference
Power Status Lamp Temp Wireless LAN

Epson EB-W06 Specifications

General

Contrast Ratio	16, 000:1
Weight	2.5 kg
Projection System	3LCD
Aspect Ratio	16:10
Projection Ratio	1.30 - 1.56:1
Screen Size	33 inches - 320 inches
Projection Lens F Number	1.49 - 1.72
Projection Lens Focal Length	16.9 - 20.28 mm
Projection Lens Focus	Manual
Security	Kensington lock, Password protection
3D	No
Resolution	WXGA (1280 x 800)
Brightness	3700 lumens
Lamp Life	12000 hours (Eco)
Keystone Correction	Vertical: ±30 degrees, Horizontal: ±30 degrees
Connectivity	HDMI, VGA, USB
LCD Panel	0.59-inch with MLA (D10)
Lamp	UHE, 210 W
Zoom	Factor: 1.2
Noise Level	37 dB (Normal)
Dimensions	302 x 237 x 82 mm (Width x Depth x Height)
Power Consumption	0.3 W (Standby)