2-23
EMP-TW1000
SEIKO EPSON Revision:A
When the (operation) indicator is lit or flashing
When the (warning) indicator is off
: Lit : Flashing
Standby condition
If you press , projection will start after a brief interval.
Warm-up in progress
Warm-up time is approximately 30 seconds.
Power off operations are ignored while warm-up is in progress.
Projection in progress
Normal operation is in progress.
cool-down in progress
Cool-down time is approximately 30 seconds.
After cool-down is complete, the projector goes to standby mode.
You cannot use the remote control or the projector's control panel
during cool-down.
If the main power switch at the rear of the projector is turned off
before cool-down is complete, wait for the lamp to cool down
(normally about one hour is required) before turning the power back
on again.
normal
Orange
Green
Green
Orange
To Next Page
Loading...
