Epson EMP-TW1000 User Manual

2-22
EMP-TW1000
SEIKO EPSON Revision:A
2.9 LED Indicators
The MA board has two LEDs that indicate the operating status of the projector.
Figure 2-25. Status Indicator LEDs Location
The following tables show what the indicators mean and how to remedy problems the they
indicate.
 When the (warning) indicator is lit or flashing
: Lit : Flashing
Internal problem / Fan problem / Sensor problem / Cinema filter problem /
Auto iris problem
Lamp problem / Lamp on error / Lamp cover open error
Check if the lamp is broken.
Clean the air filter.
Check that the lamp and the lamp cover are securely installed.
When using above an altitude of about 1500 m, make sure you set the "High Altitude Mode" to
"On".
High internal temperature
(overheating)
The lamp will switch off
automatically and projection will
stop. Wait for approximately 5
minutes. When the cooling fan
stops, turn off the main power
switch at the rear of the projector.
High-speed cooling in progress
You can continue using the
projector, but if the temperature
rises again, it will switch off
automatically.
(operation) indicator
(warning) indicator
warning/problem
Red
(Lit/off for
1 sec.)
Disconnect the power cable from the electrical outlet. Then contact your dealer
or the nearest address provided in the "International Warranty Conditions"
section of the Safety Instructions/World-Wide Warranty Terms booklet.
Red
(Lit/off for
0.5 sec.)
Replace the lamp
and then turn the
power on.
If the problem is still not solved after the lamp is
replaced, stop using the projector and disconnect
the power cable from the electrical outlet. Then
contact your dealer or the nearest address
provided in the "International Warranty
Conditions" section of the Safety Instructions/
World Wide Warranty Terms booklet.
If the lamp is
not broken
Contact your local dealer for further advice.
If the lamp is
broken
Red
• If the projector is
installed against a
wall, leave a space
of 20 cm or more
between it and the
wall.
• Clean the air filters
if they are blocked.
If the problem is not solved
when the power is turned
back on, stop using the
projector, turn off the main
power switch, and
disconnect the power cable
from the electrical outlet.
Then contact your dealer or
the nearest address provided
at "International Warranty
Conditions" in Safety
Instructions/World-Wide
Warranty Terms booklet.
Orange

Epson EMP-TW1000 Specifications

General

Brand	Epson
Model	EMP-TW1000
Category	Projector
Language	English