0-5
EMP-TW1000
SEIKO EPSON Revision:A
SAFETY INSTRUCTIONS
1. MAINTAINING OPERATOR SAFETY
1. PREVENTING ELECTRIC SHOCKS
• Turn off the power switch and disconnect the power cord from the AC outlet before car-
rying out any disassembly and assembly work on this projector.
• If power needs to be supplied to the projector while the cover is removed (such as when
making adjustments), take off any metallic objects such as wristwatches, shirt cuff but-
tons, rings and tie pins which may pose the danger of coming into contact with the pro-
jector.
2. PREVENTING INJURY
• Do not touch the lamp assy and the area around it with bare hands immediately after
turning the power off, or even after cool-down period is completed since the lamp and
the area around it may still remain hot.
• When removing the cover in order to carry out adjustments while power is being sup-
plied to the projector, be careful not to touch the fans (intake and exhaust).
• Always wear gloves when disassembling and reassembling the projector in order to
avoid injury from metallic parts with sharp edges.
• Do not look directly into the projector's lens while power is being supplied to the projec-
tor, otherwise your eyes may be injured.
3. PREVENTING ACCIDENTS
• Place the projector on a stable, level surface when carrying out any repair or adjustment
work, to prevent the projector and its components from slipping and falling down. Fur-
thermore, do not place any tools or projector components on top of or underneath the
projector.
• Avoid working on the projector in places where other people might receive injuries from
touching the projector while it is in a state of disassembly. Furthermore, do not leave the
projector unattended in the workplace at such times.
• When turning on the projector's power, always use the accessory power cord to connect
the projector to the power supply, and always make sure that the power supply is prop-
erly grounded.
To Next Page
Loading...
Need help?
General
