Epson EMP-TW1000 User Manual

5-5
EMP-TW1000
SEIKO EPSON Revision:A
5.1.3 Software DIP Switches
Some software DIP-switch settings are only accessible from the AS menu. To display the DIP-
SW Setting Menu, do the following operation.
1. Press the [Menu] button either on the remote control or on the projector's control panel for at
least 5 seconds.
2. Within 4 seconds after releasing the
[Menu] button, hit these buttons in order shown below.
[Esc] → [Esc] → [Right] → [Left]
The following sub-menu is displayed.
Switch On or Off, as necessary
Error Log No Change No Change
Spacing
(Status of acquiring
none)
Error Count No Change No Change Reset to 0
Control No Change No Change No change
DIP-SW
No
BIT Function
Default
Setting
Setting Value Note
SW1 0 reserved - - -
1reserved - - -
2DSR 1
0: disabled
1: enabled
-
3reserved - - -
4reserved - - -
5reserved - - -
6reserved - - -
7reserved - - -
Type
Clearing the Lamp
Information
Clearing the AS
Information
Clearing the Log
Information

Epson EMP-TW1000 Specifications

General

Brand	Epson
Model	EMP-TW1000
Category	Projector
Language	English