0-6
EMP-TW1000
SEIKO EPSON Revision:A
2. MAINTAINING THE PROJECTOR IN GOOD CONDITION
1. PREVENTING STATIC ELECTRICAL DAMAGE
• When disassembling and assembling the projector, always use a grounding strap and a
grounding mat. Furthermore, when replacing electrical circuit components (such as cir-
cuit boards and optical engine), bring the static-proof bag containing the new parts into
contact with a metallic section of the projector before taking out the component from the
static-proof bag.
2. USE OF GENUINE PARTS
• When replacing the structural components inside the projector (including the lamp assy),
use only replacement parts supplied by EPSON and listed in the projector's Parts List.
• Use the accessory power cord and interface cable provided with the projector.
3. SAFETY TESTING
The following tests should be carried out on repair parts used in the LCP.
Note: These are simplified tests that can be carried out at a repair centre that is not
equipped with full safety testing equipment.
Test items
1). Insulation resistance test
2). Ground continuity check
3). Illumination check
To Next Page
Loading...
Need help?
General
