3-7
EMP-TW1000
SEIKO EPSON Revision:A
Remedy For Power Supply Problems
1. Determine whether the problem is being caused by components inside the power supply
unit, or whether it is being caused by some external factor. To determine this, check factors
such as output voltage, internal temperature, appearance of components, odors and smoke.
2. If the cause is judged to be an internal problem, replace the power supply unit. If the newly-
replaced power supply unit also has a problem and the symptoms are the same as before,
then the cause of the problem is probably some external factor. Eliminate the external factor
that is causing the problem.
3. If the power supply unit is recoverable but is not working properly, for example if high tem-
peratures are causing the thermostat to shut down the power supply, or if the overcurrent
protection circuit has tripped, then there is no need to replace the power supply unit.
4. If the power supply unit is not recoverable and is not working properly, for example if an
overcurrent has repeatedly blown the fuse, replace the power supply unit.
(Continued from previous page)
B
Is the lamp turned on? Replace the Optical Engine.
Yes
To START
Press the [Power] button to
turn off the power.
Does the indicator flash
orange?
Replace the Optical Engine.
Yes
To START
Does the indicator light
orange within about 30 seconds
after it flashes orange?
Replace the Optical Engine.
Yes
To START
Image Display and Quality
No
No
No
To Next Page
Loading...
Need help?
General
