4-18
EMP-TW1000
SEIKO EPSON Revision:A
7. Remove the screw (C.C.P-TITE SCREW, 3x6, F/ZN-3C) that secures the RC Board Assy.,
and remove the RC Board Assy.
8. Remove the RCR Cable; FIF from the RC Board Assy.
9. Remove the RC Filter from the Front Case Unit; F.
10. Remove the Exhaust Duct Cushion from the Front Case Unit; F.
Figure 4-12.
C A U T I O N
When connecting the RCR Cable; FIF, route the cable toward the Projection
Lens as shown in the Figure 4-13.
Figure 4-13.
Cushion, Duct, Exhaust
RCR Cable; FIF
Filter, RC
Printed Circuit Board Assembly; RC_R1
RCR Cable; FIF
Projection Lens
To Next Page
Loading...
