Settings item Settings value Explanation
Platen Gap 1.6 Displayed when in Paper Type, Custom Paper is selected. When
registering Custom Paper, this is the Platen Gap (distance between
print head and paper) for the paper selected in Change Reference
Paper, therefore this does not normally need to be changed.
Change to a wider setting (a higher value) if print results are
smeared.
2.1
2.6
Top/Bottom Margins
Standard
*
Setting this to Standard will set the top/bottom margins as follows
depending on the printer driver print targets.
❏ CAD/Line Drawing: 3 mm/3 mm
❏ Other: 30 mm/30 mm
Left and right margins will remain at 3 mm regardless of settings. If
there is any soiling to the top section of the print results, then try
increasing the top margin before printing.
U “Printable area” on page 163
Top 3 mm/Bottom
3 mm
Top 15 mm/
Bottom 15 mm
Top 45 mm/
Bottom 15 mm
Back Tension Auto If there is any wrinkling on the paper during printing, set this to
High or Extra High.
Standard
High
Extra High
Drying Time
Drying Time per Pass 0.0 to 10.0
seconds (0.0
*
)
Select the time the print head pauses to allow drying after each
pass. Choose from values between 0.0 and 10.0 seconds.
Depending on the paper type, the ink may take a while to dry. If the
ink blurs on the paper, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
Drying Time per Page 0.0 to 60 minutes
(0.0
*
)
Specify how long the printer pauses to allow the ink to dry after
printing each page; choose from values between 0.0 and 60
minutes. Depending on the ink density or paper type, the ink may
take a while to dry. If the ink blurs on the paper, set a longer time
for drying the ink. The longer the drying time, the more time
required for printing.
Auto Cut
On
*
Choose On to automatically cut roll paper using the built-in cutter
as each page is printed or O to disable auto paper cutting. Setting
this to On automatically cuts the edge when the edge is not a
horizontal cut when setting paper. The setting selected with the
printer driver takes priority when the printer driver is used.
U “Cutting the Roll Paper” on page 30
O
Manage Remaining Amount
SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series User's Guide
Using the Menu
110
To Next Page
Loading...
Need help?
General