Replacing the Cutter
Replace the cutter when it is not cutting paper cleanly.
Supported cuttersU “Options and Consumable
Products” on page 154
Use a cross-head screwdriver to replace the cutter.
Make sure you have a cross-head screwdriver with you
before you start work.
Caution:
Store the cutter out of reach of children. e
cutter's blade could cause an injury. Pay careful
attention when replacing the cutter.
c
Important:
❏ Dropping the cutter, or knocking it against
hard objects may chip the blade.
❏
e
protective material and sheet is to protect
the blade on the new cutter. Do not remove
them until you are instructed to do so.
A
From the Home screen, touch Settings -
Maintenance - Replace Cutter.
e Replace Cutter screen appears.
B
Tou ch Start and open the cutter cover.
C
Loosen the screw holding the cutter in place
using a cross-head screwdriver and pull the
cutter straight out.
Note:
Place the used cutter in a plastic bag, then dispose
of in accordance with regional ordinances, and as
directed by local government.
D
Install the new cutter.
Insert the cutter so that the pin on the printer
matches up with the hole on the cutter. Use a
cross-head screwdriver to tighten down the
screw to hold the cutter in place.
SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series User's Guide
Maintenance
138
To Next Page
Loading...
