C
Select the size
specication
method from
Width, Length, and Scale to and then enter the
setting value.
e print image is enlarged or reduced so that it
becomes the specied width, length, or scale
while maintaining the aspect ratio of the print
data.
Windows
Mac
D
Check other settings, and then start printing.
Printing at Non-Standard
Sizes
Before printing at non-standard sizes, including
vertical or horizontal banners and documents with
equal sides, save the desired paper size in the printer
driver. Once they have been saved in the printer
driver, custom sizes can be selected in the application
Page Setup and other print dialogs.
e following sizes can be used.
Paper
Width
SC-T5100 Series /
SC-T5100N Series
89 to 914 mm
SC-T3100 Series /
SC-T3100N Series
89 to 610 mm
Paper
Length
*
127 to 18000 mm
*: The paper length can be longer when using an application
that supports banner printing. However, the actual print
size depends on the application, the paper size loaded in
the printer, and the computer environment.
c
Important:
❏
e
smallest size supported by the printer is 89
mm wide × 127 mm long. When a smaller size
than this is set in Custom Paper Size... of the
printer driver, trim the unnecessary margins.
❏ For Custom Paper Sizes of a Mac, although
you can specify a large paper size which
cannot be loaded in this printer, it will not be
printed properly.
❏ e available output size is limited depending
on the application.
SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series User's Guide
Printing with the Printer Driver from Your Computer
64
To Next Page
Loading...
Need help?
General
