Safety Instructions
Important Safety Instructions
Read all of these instructions and save them for later reference.
Follow all warnings and instructions marked on the printer.
❑
Do not place the printer on an unstable surface or near a
radiator or heat source.
❑
Place the printer on a flat surface. The printer will not
operate properly if it is tilted or at an angle.
❑
Do not block or cover the openings in the printer’s cabinet.
Do not insert objects through the slots.
❑
Use only the type of power source indicated on the printer’s
label.
❑
Connect all equipment to properly grounded power
outlets. Avoid using outlets on the same circuit as
photocopiers or air control systems that regularly switch
on and off.
❑
Do not use a damaged or frayed power cord.
❑
If you use an extension cord with the printer, make sure
the total ampere rating of the devices plugged into the
extension cord does not exceed the cord’s ampere rating.
Also, make sure the total ampere rating of all devices
plugged into the wall outlet does not exceed the wall
outlet’s ampere rating.
❑
Unplug the printer before cleaning. Clean with a damp
cloth only. Do not spill liquid on the printer.
❑
Except as specifically explained in this guide, do not
attempt to service the printer yourself.
Proof Sign-off:
Ishizaka _______
Nomoto _______
Keith _______
Grady _______
R
Fiji2 Ref. Guide
Rev.b
A5 size Introduction
05-20-97 DR, pass 0
Safety Instructions
1
To Next Page
Loading...
Need help?
General