Note:
If you wish to make a floppy disk version of the printer software
included on your CD-ROM, click the
Driver disk creation
utility
button and follow the on-screen instructions.
3. Select your printer icon in the EPSON Printer Utility Setup
dialog box.
4. Make sure EPSON Stylus COLOR 600 is selected, and click
OK
to start the printer software installation. Follow the
on-screen messages and when the installation is complete,
click
OK
again.
Your printer software is now installed. For information on
opening and using the software, see Chapter 3, “Printing With
Windows.”
Installing in Windows 95 (using plug-and-play)
Follow these steps to install the printer software using
Windows 95 plug-and-play capabilities.
Note:
To install the printer software using Windows* 95 plug-and-play
capabilities, your computer’s parallel port must be an IEEE 1284
compatible, bidirectional parallel port. See your computer
documentation for more information.
3102
L
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 2
05-29-97 DR, pass 0
2-14
Getting Started
To Next Page
Loading...
