Connecting the Printer to Your Macintosh
To use the printer’s built-in serial interface, you will need
an Apple System Peripheral-8 cable. Read the following steps
to connect the printer to your Macintosh.
1. Make sure both your printer and Macintosh are switched off.
2. Connect one end of the interface cable to the serial connector
on the back of the printer.
3. Connect the other end of the interface cable to either the
modem port or printer port on the Macintosh. The ports are
marked with the following icons.
4. Turn on the printer by pressing the
P
power button.
5. Turn on your Macintosh.
See “Installing the Printer Software in Your Macintosh” for
instructions on installing the printer software. You must install
the printer software before using your printer.
new1
modem port
printer port
em-17,18
L
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 2
05-29-97 DR, pass 0
2-20
Getting Started
To Next Page
Loading...
Need help?
General