❑
Once you install an ink cartridge, do not open the clamp or
remove the cartridge except to replace it with a new one.
The cartridge may become unusable otherwise.
❑
Install the ink cartridge immediately after you remove it
from its package. Leaving the cartridge unpacked for a long
time before use may result in reduced print quality.
❑
Do not use an ink cartridge beyond the date printed on the
cartridge carton. For best results, use up the ink cartridges
within six months of installing them.
❑
Do not shake an ink cartridge; this can cause leakage.
❑
Always turn the printer off using the
P
power button.
When this button is pressed, the
P
power light flashes
briefly then goes out. Do not unplug the printer or turn off
the power to the outlet until the
P
power light is off.
❑
Before transporting the printer, make sure the print head is
capped in the far right position and the ink cartridges are in
place.
E
NERGY
S
TAR Compliance
As an
E
NERGY
S
TAR Partner, EPSON has
determined that this product meets the
E
NERGY
S
TAR guidelines for energy efficiency.
The International
E
NERGY
S
TAR Office Equipment Program
is a voluntary partnership with the computer and office
equipment industry to promote the introduction of
energy-efficient personal computers, monitors, printers, fax
machines, and copiers in an effort to reduce air pollution
caused by power generation.
R
Fiji2 Ref. Guide
Rev.b
A5 size Introduction
05-20-97 DR, pass 0
Safety Instructions
3
To Next Page
Loading...
Need help?
General