Plugging in the Printer
1. Make sure that the printer is turned off. It is off when the
P
power button protrudes slightly from the surface of the
control panel.
2. Check the label on the back of the printer to make sure the
voltage required by the printer matches that of the
electrical outlet you will be plugging it into. Also, make
sure that you have the correct power cable for your power
source.
c
Caution:
It is not possible to change the printer’s voltage. If the
rated voltage and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the
power cord.
3. If the power cord is not attached to the printer, connect it to
the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
e3a
2
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 2
05-29-97 DR, pass 0
Getting Started
2-5
To Next Page
Loading...
Need help?
General