Attaching the Paper Support
Insert the paper support into the slots at the rear of the printer
as shown below.
Note:
To print on transparencies, you need to reposition the paper support
as described in “Loading Transparencies” in Chapter 6.
Choosing a Place for the Printer
Follow the guidelines listed below when placing your printer.
❑
Place the printer on a flat, stable surface. The printer will
not operate properly if it is tilted or at an angle.
❑
Place the printer close enough to the computer for the
interface cable to reach it easily.
❑
Leave adequate room for easy operation and maintenance.
❑
Leave enough room on the table at the front of the printer
to lower the output tray.
e29-e
2
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 2
05-29-97 DR, pass 0
Getting Started
2-3
To Next Page
Loading...
Need help?
General