Aligning the Print Head
If you notice a misalignment of vertical lines, you may be able
to solve these problems from your computer using the Print
Head Alignment utility in the printer software.
If you are using DOS or you cannot align the print head with
this utility, see Appendix A.
Note:
Do not start the Print Head Alignment utility while printing is in
progress; otherwise your printout may be marred.
For Windows users:
1. Make sure paper is loaded in the sheet feeder.
c
Caution:
Use paper at least 210 mm (8.27 inches) wide; for
example, A4 size paper loaded short edge first. Otherwise,
the print head will spray ink directly onto the platen,
which could mar future printouts.
2. Access the Utility menu as described in Chapter 4.
3. Click the
Print Head Alignment
button.
4. Follow the messages on your screen to align the print head.
8
Troubleshooting
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 8
05-29-97 DR, pass 0
Troubleshooting
8-29
To Next Page
Loading...
Need help?
General