For Macintosh users:
1. Make sure paper is loaded in the sheet feeder.
c
Caution:
Use paper at least 210 mm (8.27 inches) wide; for example,
A4 size paper loaded short edge first. Otherwise, the print
head will spray ink directly onto the platen. This may
cause any documents you print afterwards to be smeared.
2. Choose
Utility
from the Print dialog box.
3. Click the
Print Head Alignment
button.
4. Follow the messages on your screen to align the print head.
Ink Cartridge Problems
If output quality does not improve even after cleaning and
aligning the print head, you may need to replace one or both of
the ink cartridges.
To replace an ink cartridge while the
B
and
A
ink out lights are
off, follow these steps.
If the
H
or
I
ink out light is flashing or is on, replace the empty
ink cartridge as described in “Replacing an Ink Cartridge” on
page x-xx.
c
Caution:
❑
Once you remove an ink cartridge it becomes unusable and
cannot be reinstall even if ink remains.
❑
Leave the old cartridge installed in the printer until you
are ready to replace it with a new one.
1. Make sure the printer is on. The
P
power light should be on,
but not flashing.
L
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 8
05-29-97 DR, pass 0
8-30
Troubleshooting
To Next Page
Loading...
Need help?
General