Transporting the Printer
If you need to transport your printer some distance, carefully
repack it using the original box and packing materials as
follows:
1. Open the printer cover and make sure that the print head is
capped. It is capped when it is in the far right (home)
position. If the print head is not capped, turn on the printer;
then turn it off again. The print head returns to the home
position and is capped. Close the printer cover.
c
Caution:
Leave the ink cartridges installed when you transport the
printer. Removing the cartridges during transport can
damage the printer.
2. Unplug the power cord from the electrical outlet; then
disconnect the interface cable from the printer.
3. Remove the paper from the sheet feeder and remove the
paper support.
4. Push in the output extension tray, and then raise the output
tray.
5. Attach the protective materials to the printer.
6. Repack the printer and power cord in the original box.
7. Keep the printer level during transport.
7
Maintenance
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 7
05-20-97 DR, pass 0
Maintenance and Transportation
7-9
To Next Page
Loading...
Need help?
General