If you are using the floppy disk version of the software, before
you begin installation, make a backup copy of the EPSON
printer software disk. If you wish to make a floppy disk
version of the printer software on your CD-ROM, you can use
the driver disk creation utility included on the CD. See page
2-15 for Windows 95, or page 2-18 for Windows 3.1.
Installing in Windows 95
Follow the steps below to install the printer software in
Windows 95.
1. Make sure Windows 95 is running and the printer is off.
2. Insert the printer software CD shipped with your printer in
the CD-ROM drive. Click
Install
in the dialog box that
appears, shown below.
If this dialog box does not appear when you insert the printer
software CD, double-click the
My Computer
icon, then
double-click the CD-ROM drive icon (or floppy disk drive
icon if using the floppy disk version). If the dialog box
shown above still does not appear, double-click the
Setup.exe
icon. You may need to use the arrows to scroll
through the folder to find it.
cdinst1
2
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 2
05-29-97 DR, pass 0
Getting Started
2-13
To Next Page
Loading...
Need help?
General