2. Access the printer driver setting menu as described in
Chapter 4.
3. Click the Utility tab, then click the
Head Cleaning
button.
4. Follow the on-screen messages.
The
P
power light flashes while the printer performs the
cleaning cycle. This operation takes about two minutes to
complete.
c
Caution:
Never turn off the printer while the
P
power light is
flashing. Doing so may damage the printer.
5. When the
P
power light stops flashing, click
Print nozzle
check pattern
in the Head Cleaning dialog box and use
the pattern to confirm that the head is clean and to reset the
cleaning cycle.
Nozzle check pattern:
The above sample is in black and white, but the actual check pattern
prints in color.
In the check pattern, if you find that any segments are missing
from the test lines, you may need to repeat the head cleaning
and print the nozzle check pattern again.
If print quality hasn’t improved after repeating this procedure
four or five times, follow the recommendations listed in this
chapter. If the print quality still has not improved, contact your
dealer.
8
Troubleshooting
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 8
05-29-97 DR, pass 0
Troubleshooting
8-27
To Next Page
Loading...
Need help?
General