EasyManuals Logo

Epson Stylus color 600 User Manual

Epson Stylus color 600
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #154 background imageLoading...
Page #154 background image
5. Lift the cartridge out of the printer and dispose of it properly.
Do not take the used cartridge apart or try to refill it.
w
Warning:
If ink gets on your hands, wash them thoroughly with soap
and water. If ink gets into your eyes, flush them
immediately with water.
6. Remove the ink cartridge from its protective bag. Next,
remove only the yellow tape seal from the cartridge as
shown below.
c
Caution:
You must remove the yellow tape seal from the
cartridge. Leaving the tape on when you install the
cartridge will permanently damage it.
Do not remove the tape seal from the bottom of the
cartridge; otherwise, ink will leak.
7. Lower the ink cartridge into the cartridge holder with
the label on the cartridge face up and the arrow on the
cartridge pointing to the rear of the printer.
black S020093
color S020089
36
L
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 8
05-29-97 DR, pass 0
8-32
Troubleshooting

Table of Contents

Other manuals for Epson Stylus color 600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson Stylus color 600 and is the answer not in the manual?

Epson Stylus color 600 Specifications

General IconGeneral
BrandEpson
ModelStylus color 600
CategoryPrinter
LanguageEnglish

Related product manuals