Paper Handling
1-5
❏
When the adjust lever is in the “+” position, make sure that the
High Speed
check box in the printer driver’s Advanced dialog
box is cleared. To clear this check box, you may also need to
change the Print Quality setting or align the print head using
the Print Head Alignment utility.
❏
If you wish to print on the reverse side of an Ink Jet Card with
Maximum
selected as the Printable Area setting, flatten the
card or curl it slightly toward the opposite side before loading.
Set the adjust lever to the “+” position before printing.
To Next Page
Loading...
Need help?
General