82
2. Setting for media position detection
This procedure is not required when media position detection is not changed.
1
Turn the power on.
2
Remove the paper in the printer.
3
Display the printer driver window. (See How to Use the Printer Driver on
page 160 for how to display the driver window.)
4
Change [Media position detection] on [Maintenance And Utilities] tab
of the printer driver depending on the paper to use.
5
Turn the power off.
When paper remains in the printer, media position detection cannot be set.
Be sure to remove the paper before turning on the printer.
Roll paper type Media position detection setting
Receipt/Full-page Label/Transparent Full-page Label Not applied
Black Mark Die-cut Label Detects black marks of die-cut label
Black Mark Receipt/Wrist Band Detects black marks of receipt
Die-cut Label/Black Mark Die-cut Label
/Transparent Die-cut Label
Detects the gap between labels
The changed setting of the media position detection is saved in the NV memory of the
printer when the printer is turned off. Be sure to turn off the printer to enable the setting.
To Next Page
Loading...
Need help?
General