Epson WorkForce WF-2880 Series - Checking the Software Status; Paper Does Not Feed Correctly; Removing Jammed Paper

2.
Click Options & Supplies > Utility > Open Printer Utility.
3.
Click EPSON Status Monitor.
You can check the printer status, ink levels, and error status.
Checking the Software Status
You may be able to clear the problem by updating the soware to the latest version. To check the soware status,
use the soware update tool.
Related Information
& “Application for Updating Soware and Firmware (EPSON Soware Updater)” on page 177
& “Installing the Latest Applications” on page 178
Removing Jammed Paper
Follow the on-screen instructions on the printer's control panel to locate and remove the jammed paper including
any torn pieces. e LCD screen displays an animation that shows you how to remove jammed paper.
!
Caution:
Never touch the buttons on the control panel while your hand is inside the printer. If the printer starts operating, it
could cause an injury. Be careful not to touch the protruding parts to avoid injury.
c
Important:
Remove the jammed paper carefully. Removing the paper vigorously may cause damage to the printer.
Paper Does Not Feed Correctly
Check the following points, and then take the appropriate actions to solve the problem.
❏ Place the printer on a at surface and operate in the recommended environmental conditions.
❏ Use paper supported by this printer.
❏ Follow the paper handling precautions.
❏ Do not load more than the maximum number of sheets specied for the paper.
❏ Make sure the paper size and paper type settings match the actual paper size and paper type loaded in the
printer.
❏ Clean the roller inside the printer.
Related Information
& “Environmental Specications” on page 221
Solving Problems > Paper Does Not Feed Correctly
185