Epson WorkForce WF-2880 Series - Ethernet Specifications; Wi-Fi Specifications

Functions Supported Remarks
Network Scanning Epson Scan 2 IPv4, IPv6 ✓ -
Event Manager IPv4 ✓ -
Epson Connect (Scan to
Cloud)
IPv4 ✓ -
AirPrint (Scan) IPv4, IPv6 ✓ OS X Mavericks or
later
Fax Send a fax IPv4 ✓ -
Receive a fax IPv4 ✓ -
AirPrint (Faxout) IPv4, IPv6 ✓ OS X Mountain
Lion or later
Wi-Fi Specications
Standards
IEEE802.11b/g/n
*1*2
Frequency Range 2.4 GHz
Maximum Radio-Frequency Power
Transmitted
19.8 dBm (EIRP)
Coordination Modes
Infrastructure, Wi-Fi Direct (Simple AP)
*3
Wireless Securities
WEP (64/128bit),WPA2-PSK (AES)
*4
*1 Complies with either IEEE 802.11b/g/n or IEEE 802.11b/g depending on location of purchase.
*2 IEEE802.11n is only available for the HT20.
*3 Not supported for IEEE 802.11b.
*4 Complies with WPA2 standards with support for WPA/WPA2 Personal.
Ethernet Specications
Standards
IEEE802.3i (10BASE-T)
*1
IEEE802.3u (100BASE-TX)
IEEE802.3az (Energy Ecient Ethernet)
*2
Communication Mode Auto, 10Mbps Full duplex, 10Mbps Half duplex, 100Mbps
Full duplex, 100Mbps Half duplex
Connector RJ-45
*1 Use a category 5e or higher STP (Shielded twisted pair) cable to prevent risk of radio interference.
*2 The connected device should comply with IEEE802.3az standards.
Appendix > Technical Specications > Ethernet Specications
219