Epson WorkForce WF-2880 Series - Receiving Faxes on the Printer; Setting Receive Mode

❏ Inside of Image: Sends a fax with header information approximately 7 mm lower than the top of the
scanned image.
e
header may overlap with the image, however, the fax received by the recipient will not
be split into two documents.
4.
Select the Fax Header eld, and then select the header you want to use.
5.
Select one of the Additional Information options as necessary.
6.
Select OK to apply the settings.
Related Information
& “Fax Settings” on page 141
Sending Dierent Size Documents Using ADF (ADF Continuous Scan)
If you place dierent sized originals in the ADF, all of the originals are sent at the largest size among them. You can
send them in their original sizes by sorting and placing them by size, or placing them one by one.
Before placing originals, make the following setting.
Select Fax on the home screen, select the Fax Settings tab, and then tap ADF Continuous Scan to set this to On.
e printer stores the scanned documents, and sends as one document.
Note:
If you leave the printer untouched for 20 seconds aer prompted to set the next originals, the printer stops storing and starts
sending the document.
Receiving Faxes on the Printer
Setting Receive Mode
You ca n m a k e a Receive Mode using Fax Setting Wizard. When making fax setting at the
rst
time, we
recommend you to use the Fax Setting Wizard. If you want to change only the Receive Mode, follow the
instruction below.
1.
Select Settings on the home screen.
2.
Select General Settings > Fax Settings > Basic Settings > Receive Mode.
3.
Select the Receive Mode depending on your use.
c
Important:
If a phone is not connected, you must select Auto.
Faxing > Receiving Faxes on the Printer > Setting Receive Mode
127