Troubleshooting Hardware Problems
5-34 SmartEdge 1200 Router Hardware Guide
Table 5-36 lists the cards for which ODD tests are supported and the values for the card-type and slot
arguments; in the table, the IR abbreviation is used for Intermediate Reach.
Perform the following steps to initiate an ODD session:
1. If you are testing a traffic card, change its state to ODD; otherwise, proceed to step 2. To prepare a
traffic card for an ODD session, perform the tasks listed in Table 5-37; Table 5-36 lists values for the
card-type and slot arguments.
Table 5-36 Card Types and Slots for the card Command
Type of Traffic Card and Description card-type Keyword slot Argument Range
ATM
Enhanced ATM OC-12c/STM-4c IR atm-oc12e-1-port 1 to 6 and 9 to 14
4-port ATM OC-3c/STM-1c IR atm-oc3-4-port 1 to 6 and 9 to 14
Ethernet and Gigabit Ethernet
10/100 Ethernet ether-12-port 1 to 6 and 9 to 14
FE-GE fege-60-2-port 1 to 6 and 9 to 14
Gigabit Ethernet (first and second versions) gigaether-4-port 1 to 6 and 9 to 14
Gigabit Ethernet 3 ge3-4-port 1 to 6 and 9 to 14
Gigabit Ethernet 1020 (10-port) ge-10-port 1 to 6 and 9 to 14
Gigabit Ethernet 1020 (20-port) ge-20-port 1 to 6 and 9 to 14
10 Gigabit Ethernet 10ge-1-port 1 to 6 and 9 to 14
SONET/SDH
OC-192c/STM-64c (any XFP version) oc192-1-port 1 to 6 and 9 to 14
Table 5-37 Prepare a Traffic Card for an ODD Session
# Task Command Notes
1. Access global configuration mode. configure Enter this command in exec mode.
2. Specify the card to be tested and access
card configuration mode.
card Specify the card type and slot number.
3. Save the state of the ports and circuits on
the card and put it in the out-of-service state.
shutdown If there are cross-connected circuits configured on
any of the ports on an ATM or Ethernet card, this
command disables the cross-connections and saves
their state.
4. Put the card in the ODD state. on-demand-diagnostic
5. Commit the previous commands to the
database and return to exec mode.
end You must enter this command to place the card in
the ODD state.
To Next Page
Loading...
Need help?
General
