10 TOOLS
0460 896 274
- 72 -
© ESAB AB 2013
In the dialogue box, you are asked if you want to store the selected storage point. Press
YES to save the value. The storage point's values can be seen under the line at the bottom.
With AUTO, the limits are set automatically according to the most recently used
measurement values.
and then STORE if the setting is to be retained.
10.6 Production statistics
Main menu → Tools → Production statistics
The production statistics will keep track of the total arc time, the total amount of material and
the number of welds since the most recent reset. They will also keep track of the arc time
and the amount of material used in the most recent weld. For information purposes, the
melted wire material per length unit that has been calculated and when the most recent reset
occurred are also displayed.
The number of welds does not increase if the arc time has been shorter than 1 second. For
this reason, the amount of material used for a short weld of this type is not displayed.
However, material consumption and time are included in the total material consumption and
time.
When you press RESET, all counters are reset. Date and time show the most recent reset.
If you do not reset the counters, these are all automatically reset when one of them has
reached its maximum value.
To Next Page
Loading...
