IP Server 900 Programming Manual Function 1: System function programming
D.9
Field 7: PRI local number digit length
Tells the system whether there is seven- or 10-digit local dialing in the system’s area. If the local calling
area uses only seven-digit dialing, set this value to 7 (this tells the system not to wait for additional digits
when a local seven-digit number is dialed).
Range: 7 or 10. Default: 10 (supports both 10- and seven-digit dialing).
Field 8: Dialing off-hold
Enables or disables outside callers’ ability to dial off-hold only when MOH 590 (external source) is
selected. When this is enabled, CO callers will be able to dial extension, department, and mailbox
numbers while on hold. When this is disabled, the system will ignore digits dialed by CO callers. To
enable or disable outside callers’ ability to dial off-hold, press a scroll key to make the desired selection
and then press # to confirm.
Default: Enabled.
Field 9: Re-sending of Caller ID in Intelligent Call Forwarding (PRI)
This parameter “turns off” the repeat Caller ID (re-sending) component of Intelligent Call Forwarding in
PRI. Some service providers — local exchange carriers or inter-exchange carriers — don’t allow repeating
the caller’s CID data when making an outgoing call.
If re-sending of Caller ID is disabled, the PRI pilot number of the station’s tenant will be sent instead.
If re-sending of Caller ID is enabled, CO calls that are forwarded to an off-premises number over a PRI
channel will send the original caller’s CID data to the called person. To enable or disable this parameter,
press a scroll key to make the desired selection and then press # to confirm.
Default: Enabled.
Note: Call forwarding off-premises and call forwarding no-answer/off-premises will be unaffected by
changes to this parameter.
Field 10: Re-sending of Caller ID in Intelligent Call Forwarding (SIP)
This parameter “turns off” the repeat Caller ID (re-sending) component of Intelligent Call Forwarding in SIP
trunking. Some service providers — local exchange carriers or inter-exchange carriers — don’t allow
repeating the caller’s CID data when making an outgoing call.
If re-sending of Caller ID is disabled, the SIP pilot number of the station’s tenant will be sent instead.
If re-sending of Caller ID is enabled, CO calls that are forwarded to an off-premises number over SIP
trunking will send the original caller’s CID data to the called person. To enable or disable this parameter,
press a scroll key to make the desired selection and then press # to confirm.
Default: Enabled.
Note: Call forwarding off-premises and call forwarding no-answer/off-premises will be unaffected by
changes to this parameter.
Field 11: Fax call default destination
This parameter determines where fax calls detected by the system auto attendant will be routed.
If this field is left at the default setting of ANALOG the system will route faxes that are detected by the auto
attendant to the lowest-numbered extension in the system that has a type of Fax in Function 31.
If this field is set to ESI FAX the system will route faxes detected by the auto attendant to the IP Server
900’s built-in Fax over e-mail feature.
Default: ANALOG.
Note: With a setting of ESI FAX the system will send a notification e-mail to the system’s operator extension
with the fax attached as a .PDF file.
To Next Page
Loading...
