ESI 900 - Assign each CO line’s tenant; Assign outbound CO line groups; Assign a distinctive CO ring tone

IP Server 900 Programming Manual Function 2: CO line programming
E.6
3. Assign each CO line’s tenant
The tenant parameter
1
is used here to have each CO line follow the day/night mode of the tenant to which it’s
assigned. The day/night mode can be changed either by the day/night programmable feature key on a
station in the same tenant as the CO or by the day/night table assigned for that tenant in Function 43 (see
page G.7).
4. Assign outbound CO line groups
CO lines can be grouped for outbound, pooled access into one of eight line groups: 9, 8, 71, 72, 73, 74,
75, or 76.
Note: A line can only be in one line group or designated as a private line.
Select the line group and press the # key to confirm. Outgoing calls will be assigned from the highest CO
to the lowest available. Or, to delete the line group number (whereupon the line can only receive inbound
CO line calls), press HOLD.
Default: 9 (i.e., all CO lines in Group 9).
Note: To assign a CO line for incoming traffic only, don’t enter a CO line group here.
Private line
You can designate a line as a private line by entering an extension number, instead of a line group
number, in this step. The line is then programmed as outlined in the following explanation, giving the
private line great flexibility for handling call routing.
Notes: Private lines don’t follow ARS.
2
A private line can be assigned only to an ESI phone (desktop model or Cordless Handset). A line
key must be programmed on the phone to access the line for outgoing calls. If the line key is
programmed on another phone, it can be used ONLY for incoming access (it may also serve just
as a purely visual indicator).
5. Assign a distinctive CO ring tone
A distinctive CO ring tone overrides the station ring tone for incoming calls. Select one of the six available
tones to enable the feature, or select NORMAL to disable the feature.
Range: 1–6 and normal (disabled). Default: Normal (disabled).
1
To view and change the tenant number, you must first have enabled tenant service in Function 169 (see page D.11).
2
Automatic route selection.