ESI 900 - Page 47

IP Server 900 Programming Manual Function 2: CO line programming
E.17
6. To select a distinctive ring tone for the new line. and press # to confirm.
Range: Normal and ring tones 1–6. Default: Normal.
CO RING TONE
TONE NORMAL
7. This line is programmed to be answered as displayed. To select a specific station, mailbox, or branch ID
or to specify the internal ESI Fax over e-mail server as the destination which should answer this,
press a scroll key and enter the new value, and press # to confirm. (If the current value is
acceptable, just press # to confirm.)
Default: ID 1.
RING 1
ID: 1
8. Select the line keys that are to have the same programming during night mode, and press # to confirm.
For this example, we’ll be using the IP/ASC Carrier Card in position 1 (“CC 1”).
Below, XX–XX represents the SIP ports as they are installed in the system.
CC 1 SIP NGT
52-59 >
9. Use the scroll keys to select the SIP provider to be used for the selected trunks, and press # to confirm.
Again in this example, we’ll be using SIP provider 1.
Range: 1–10 (as previously defined in Function 2142 [page E.18]).
Note: During night mode programming, this is a read-only field.
SEL PROVIDER #
1-BROADVOX
10. Enter the line name (if you want to use a different one than what appears), and press # to confirm.
If you need detailed information about entering characters, press HELP.
Range: Up to 10 characters. Default: [Blank].
CO LINE
NAME:
11. If tenant service is enabled in Function 169 (page D.11), use the scroll keys to select the tenant
number, and press # to confirm. (If tenant service isn’t enabled, press # to move to the next step.)
Range: [Any valid tenant number]. Default: 1.
CO LINE
TENANT: 1
12. To select a distinctive ring tone for the new line. and press # to confirm.
Range: Normal and ring tones 1–6. Default: Normal.
CO RING TONE
TONE NORMAL
(Continued)