PLATINOUS SERIES CONTROLLER MANUAL
13
3. Constant Mode Setup
This chapter explains how to set up the constant mode. The constant mode is the basic chamber
operating mode.
3.1. Constant Mode Setup
The following procedure explains how to make control settings for the constant mode.
1. Get the constant setup mode.
Press the Constant Setup box on the main menu.
TEMP.
2. Input the target temperature (& humidity).
Pressing the field box next to Temp. SP and Hum. SP lays a keypad over the screen to
enable input. Make your input from there.
* If OFF is displayed next the Hum. SP, the target humidity cannot be set. Turning humidity
control ON will enable input.
To Next Page
Loading...
Need help?
General
