PLATINOUS SERIES CONTROLLER MANUAL
36
3. Press the Setup button under the Start button.
4. Set up the start timer.
Set the start mode, operation mode, date, time and the day of the week.
Table 5.1. Start Timer Setup Screen Elements
1 Time Starts the chamber at the specified time on one
special day.
Start Mode
Day-by-Day Starts the chamber at the specified time only on
specified days.
Everyday Starts the chamber everyday.
Operation
Constant Starts the chamber in the constant mode when
the timer overflows.
Mode
Program Starts the selected program when the timer
overflows.
Day of Week
For selecting the days on which to run the timer. This setting is
available only when Day-by-Day is selected for the Start Mode.
Date
For setting the date to start the timer. This setting is available only
when 1 Time is selected for the Start Mode.
Time
For setting the time to start the timer. A keypad is laid over the
screen to enable input.
To Next Page
Loading...
Need help?
General
