Evolis AGILIA - Cleaning the printer; Advanced cleaning

Maintenance
Agilia - User Guide 44
Cleaning the printer
If a Card Lamination module is installed, insert the adhesive card into the manual card feeder.

1. Remove the film from the adhesive card and insert the adhesive card into the rear output slot (adhesive side up). The cleaning starts. When the cleaning
is over, the used adhesive card is ejected into the output box.
2. Put the ribbon and film back on the cassettes and put the cassettes back in place. ( "Printing ribbon and retransfer film" on page17 ).
3. Put the cards back in the card feeder, reset the card thickness selector and close the card feeder.
4. On the LCDtouchscreen click on the return button to validate the cleaning cycle.
Advanced cleaning
When cleaning the print head:
l
Avoid any contact between the print head and any metal or sharp objects. This could permanently damage the print head.
l
Avoid touching the print head directly with your fingers, as this could affect print quality or permanently damage the print head.
Recommended cleaning cycle: Every 4800 cards.
Servicing accessories:Adhesive cleaning card with 2 adhesive-free zones, impregnated T-card (use just after the bag is opened), and cleaning
swab impregnated with isopropyl alcohol.
Cleaning cycles can also be launched from the Evolis Premium Suite 2 by clicking on the Cleaning icon on the Home page.
Cleaning cycles can be launched from the LCDtouchscreen (for printers equipped with an LCD touchscreen). Refer to the corresponding user guide
available on www.evolis.com > Support section > Product page.
When the cleaning cycle is over, wait 2 minutes before using the printer to let the alcohol evaporate.